Code 3 LED Patient Compartment Light User Manual
Important
INSTALLATION &
OPERATION
MANUAL
12VDC LED
COMPARTMENT
LIGHT
Read all instructions and warnings before installing and using.
This manual must be delivered to the end user of this equipment.
IMPORTANT:
INSTALLER:
1. Using the mounting diagram below, cut the mounting holes for the light
2. Feed the lamp assembly wires through the hole shown below. The WHITE wire is for Bright, the RED wire is for Dim
and the BLACK wire is for Ground.
operation and the Black wire is for low power operation. Use appropriate wire connectors.
3. Insert the lamp into the mounting hole. Be sure no wires are caught between the mounting surface an the lamp unit.
4. Attach the lamp to the roof of the vehicle using appropriate size screws.
Warning: You can not have insulation of any kind covering the back of the light head. This will cause
excessive heat to build up!