Code 3 LIT3 Mounting Kits Chevy Tahoe - Manual

1
INSTALLATION &
OPERATION
MANUAL
Read all instructions and warnings before installing and using.
This manual must be delivered to the end user of this equipment.
INSTALLER:
1. Adjust the mounting feet out so the face of the mount is even with the outside end of the light bar lens of
your 47" light bar or 1 5/8" in from the end of the lens for your 52" light bar.
2. Install the rubber pads onto the LIT 3 mounting feet with the thicker edge of the pad facing outboard on the
mounting feet.
3. Choose the proper rubber pads based on the desired mounting position (see Figs 1, 2 & 3). The pads are
marked A, B, C & D per the chart below.
4. Install the thicker mounting pads in the front position on the LIT3 foot (one each side of vehicle) see Fig 1.
5. Install the thinner mounting pads at the rear position of the LIT3 foot (one each side of vehicle) see Fig 1.
6. Center light bar onto roof of vehicle. The outboard roof stiffener ridge should be located at the transition
point of the LIT 3 mounting foot.
7. Position DS and PS brackets onto roof edge of vehicle and mark screw installation points on the vehicle
door frame areas. Use the drill point screws provided with the installation hardware.
NOTE: Use of a punch to center screw locations will also provide greater holding power to screw threads.
8. Install two 3" phillips head SS mounting bolts through mounting brackets and into the cage nut on each
mounting foot. Tighten screws alternately between DS and PS of vehicle until light bar is securely held in the
center of the roofline. The final torque should be 18 inch lbs for each of the four screws. Do not over tighten.
2007 - 2010
CHEVY TAHOE LIGHT
BAR ROOF MOUNT
ADAPTOR BRACKET
AND LIT3 MOUNTING
FEET
CHEVY TAHOE
IMPOR- IMPORTANT:
INSTALLER:
Fig 1