Specifications, Maintenance, Figure 1 – Code 3 Motorcycle Sirens 3951, 3955 User Manual

Page 22: Model 395 siren wiring diagram, Code 3

Advertising
background image

5

Figure 1

PIN FUNCTION

A1

GROUND

A3

SPEAKER +

C1

+12V DC

C3

SPEAKER -

D1

AIR HORN

D2 PA

PTT

E1

MIC LO

E2

MIC LO

F1

YELP

F2

WAIL

F3

MIC HI

ALL OTHER PINS NOT USED

14AWG RED

+12VDC

10A*

FUSE

100W

SIREN

SPEAKER

14AWG

MODEL 395 SIREN WIRING DIAGRAM

14AWG

AIRHORN INPUT

AIRHORN SWITCH

14AWG BLK,

GROUND

(EARTH)

+12VDC

USER INTERFACE

+12VDC

WAIL SWITCH

PA

MIC

WAIL INPUT

Code 3, Inc., a subsidiary of
Public Safety Equipment, Inc.

5

Specifications

Input Voltage - 10 to 16 VDC, negative ground (earth).
(Note: Operation above 15 VDC for an extended period of time may result in speaker damage
Operating Current: 8A @ 13.6V with 11-ohm load ( 100W Spkr )
Standby Current: Ignition Switch input ON - Approx. 200 mA
Ignition switch input OFF- no stanby current
Cycle Rate:

WAIL - 11 cycles/minute.
YELP - 200 cycles/minute.

Voltage Output ( approx. ) 65 V peak-to-peak
Audio Response:

3 dB down points - 500 to 3000 hz.
1000 hz. 0 dB Reference

Audio Distortion:

10% or less below clipping

Maintenance

Code 3

®

Model 3955 siren has been designed to provide trouble free service. In case of difficulty, consult the

Troubleshooting Guide located on pages 6 and 7 of this manual. Also check for shorted or open wires. The
primary cause of short circuits has been found to be wires passing through firewalls, roofs, etc. If further
difficulty persists, contact the factory for troubleshooting advice or return instructions. Public Safety Equipment,
Inc. maintains a complete parts inventory and service facility at the factory and will repair or replace (at the
factory's option) any unit found to be defective under normal use and in warranty.Any attempt to service a unit,
by anyone other than a factory authorized technician, without the express written consent of the factory, will void
the warranty. Units out of warranty can be repaired at the factory for a nominal charge on either a flat rate or
parts and labor basis. Contact the factory for details and return instructions. Public Safety Equipment is not
liable for any incidental charges related to the repair or replacement of a unit unless otherwise agreed to in
writing by the factory.

Advertising