Code 3 Shield Mini Bar - Manual (Page 3)

3
Installation & Mounting
Magnetic Mounting:
The magnetic based beacon provides a secure, temporary installation on a non-moving vehicle. The beacon
should be placed in the center of the roof where the least amount of curvature occurs. Check the magnet for
debris before installation. Any foreign matter can reduce holding power and scratch the vehicle. The roof surface
should be dry and have a dull, non-glossy finish. A glossy, highly waxed surface will reduce the magnet's holding
power. The standard Code 3 magnetic mounting kit for the Shield Mini-Bar is capable of providing a combined
holding force of up to 200lbs. To ease installation and to avoid scratching the vehicle's paint when positioning
the beacon it is recommended that a thin piece of cardboard be placed under each magnet until the beacon is
positioned as desired. Then remove the cardboard, one piece at a time. Check the beacon to be certain that it is
being held securely in position and can be seen from all directions. The user should not attempt to drive with the
beacon magnetically mounted.
Permanent Mounting:
The permanent mount beacon provides a secure, permanent installation. Use the supplied brackets to mount
the beacon in the desired location. Wire routing should be taken into consideration when choosing a mounting
location.
WARNING!
As with any magnetially-mounted warning device, its use on the exterior of a moving vehicle is at the sole
discretion and responsibility of the user.
Magnetic mounting provides a secure, temporary installation on a non-moving vehicle in most circumstances
and is recommended for stationary use only.
T his device, when magnetically mounted, is not intended for use on a moving vehicle.
Magnetic Mount Permanent Mount
Magnetic Suction Mount Upgrade
To upgrade to the Magnetic Suction Mounting System, remove the (2) mounting brackets shown in the
pictures above by removing the (4) mounting bracket screws and install the (2) Suction Magnets using the
(2) mounting screws provided in the upgrade kit. See picture below.