Code 3 SmartPro Configuration Interface - Manual (Page 2)

Programming a Lightbar
1.
To program a lightbar, load a configuration into the handheld unit.
2.
Next plug the programming cable into the lightbar.
3.
Press the Write button for approx. 1 second.
4.
The operation should take 4-5 seconds.
5.
Once the unit power indicator has turned off it is safe to unplug the cable.
Reading a Lightbar
1.
Plug the programming cable into the lightbar.
2.
Press the Read button for approx. 1 second.
3.
Once the unit power indicator has turned off, it is safe to unplug the cable.