Step 2 attach the pivot arm brackets – Code 3 SuperVisor TL for 2007 Ford Expedition User Manual

Page 3

Advertising
background image

3

FIgURE 1 FIgURE 2 FIgURE 3

Step 1-Removing Sun Visor Pivot Brackets and Visor Clips

Begin the installation by removing the driver and passenger sun visors. Remove the three screws that hold the pivot arm bracket of the

sun visors to the headliner using a #15 Torx screwdriver as shown in Figure 1. Remove the single #15 Torx screw that holds the visor

clip to the headliner again using a #15 Torx screwdriver as shown in Figure 2. Carefully reach up above the headliner and pull the visor

vanity mirror light wire free to get access to the harness connector. Unplug the visor vanity mirror light wire if the vehicle is so equipped by

pushing in on the small square de tent (see Figure 3) while pulling on the connector to unplug the harness.

__

_________

___

>

Small Square Detent__

Step 3 Attach Brackets to Sun Visor Retaining Clips

Place the inner bracket on the retaining clip as shown in Figures 7 and 8. Attach the inner bracket and retaining clip to the headliner

with the Torx screw as illustrated in Figure 9. Leave the Torx screws slightly loose at this time.

Step 2 Attach the Pivot Arm Brackets

Attach the outer mounting brackets that are supplied noting the difference between passenger and driver side brackets (see Figure

4 Note: The Driver side is shown). Rotate the pivot arm on the Driver's side sun visor and verify the orientation of the outer bracket

as shown in Figure 5. Re plug the Connector that goes to the visor mirror vanity light. Carefully tuck the wire and Connector back

into the hole in the headliner. Note: Make sure the connector is pushed back away from the area where the bracket attaches

so that you don't crush it when you tighten the screws in the mounting bracket . Position the Driver's side pivot arm and attach

the three Torx screws as shown in Figure 6. Repeat this operation for the Passenger side pivot arm and outer mounting bracket.

Leave the Torx screws slightly loose at this time.

FIgURE

4

FIgURE

5

FIgURE

6

FIgURE

7

FIgURE

8

FIgURE

9

Advertising
This manual is related to the following products: