Code 3 WingMan for Crown Victoria - Manual (Page 6)

6
The bracket fasteners shown in Figures 16, 17, and 18 make excellent hard mounting
points for radar guns and video cameras, etc.
Caution: Drilling into the housing of the lightbar could damage wiring or other internal
components.
Step 12 Install the rear WingMan Bar by positioning the bar in the center of the rear window centered on the brake light housing and
position over the mounting brackets (see Figure 15). You will have to continue feeding the cable through the hole simultaneously while
moving the bar into position.
Step 13 Align the mounting holes in the WingMan Bar with the mounting bracket and mounting plate holes and insert the supplied 1/4-20 x
1/2" bolts and internal tooth lock washers (see Figures 16 and17). Make sure the spacing around the rear brake light housing is the same
all around and the perimeter shape of the mounting plates line up with the shape of the mounting brackets (it may be necessary to slightly
loosen the mounting bracket bolts in the trunk to center the lightbar around the brake light housing). After everything is centered and
aligned, tighten the bolts with a phillips screwdriver (see Figure 18).
FIGURE 15 FIGURE 16
FIGURE 17 FIGURE 18
Step 14 Finish tightening the mounting bolts in the trunk (see Figure 19).
FIGURE 19