Optional, Use template and drill holes into surface, Mount locking block – Copernicus TEC700 User Manual
Page 9
TEC700 - Version D - Released December 16, 2014 - Copernicus Educational Products Inc.
Use Template and Drill Holes into Surface
6
You will need:
(Not to Scale)
7
You will need:
(Not to Scale)
Actual Size:
Locking Block
1x
M6 x 70mm
2x
F
M6 Lock Nut
2x
G
M6 Washer
6x
H
OPTIONAL:
Positioning Template (found at back of this guide)
1x
9
Allen Key 4mm
1x
TM
Follow Steps 6 to 8 to install the Tech Tub Locking
Block and Locking Pin System
Mount Locking Block
Drilled holes from Step 6
F
H
G
Underside
Label facing
upwards
H
Table
or
Countertop
Section
View
G
F
H
Washer goes
INSIDE tube
H
Washer goes
UNDER tube
H
H
Use positioning template
found at back of these
Assembly Instructions
Use 1/4” or 6mm drill bit
Maximum thickness of
surface is 2-1/2” (63mm)
Table or Countertop
Use tape to secure
the positioning template