Chimera 1864 - Manual

1
CHIMERA
SMALL PANCAKE LANTERN ASSEMBLY INSTRUCTIONS
Item numbers 1860 and 1864
WARNING – FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS COULD
CREATE A HAZARDOUS CONDITION.
1. This product is intended for use with bare bulb instruments pointed straight
down. Refer to the light manufacturer’s recommendations before operating the
light in this position.
2. Do not leave unattended.
3. Use the light’s protective screen or shield at all times.
4. Use in a moderate temperature environment.
5. Open the Lantern’s flaps for ventilation as required.
6. Maximum power capacity for this product is
400 watts .
ASSEMBLING THE FRAME
The frame has three components. The first consists of four lengths of curved wire
attached to a small metal ring. The second consists of four aluminum tubes with
tapered tips on one end and tubular inserts on the other end. (A fifth tube is
included as a spare.) The third consists of the Speed Ring for the light you intend to
use. (Speed Ring sold separately)
1. Hold the curved wire component by the metal ring and allow the wires to hang
loose. This will permit the wires to fall into order (photo 1).
2. Insert the loose end of one of the outside wires as far as it will go into the
tapered end of the tubular component (photo 2).
3. Insert the other end of the tubular component into one of the mounting holes on
the outside corners of the Speed Ring (photo 3).
4. Assemble the remaining poles in the same manner and insert them in order in
the remaining mounting holes in the Speed Ring (photo 4).
Photo 1 Photo 2 Photo 3 Photo 4
1812 Valtec Lane, Boulder, CO 80301 303-444-8000 888-444-1812 fax 303-444-8303 [email protected]
18609800/030101