Header, Securing corner posts, Pull handle kit – Coral Industries 6000 Neo-Angle Swing Door (Traditional) - 846 User Manual
Page 8
846-GP 12/05
Position header over unit and lower into place.
Join header to jambs by drilling, from inside
shower, through long leg of header into jambs.
Secure using 8A x 3/8" truss head screws (J).
Join header to corner posts by drilling, from
inside shower, through long leg of header into
corner posts. Holes should be 1/2" from
corner joining. Secure using 8A x 3/8" truss
head screws.
8A x 3/8" Truss
Head Screws
Door Panel
Header
Side Panel
When securing header, do not drill
through front side of header or hit glass
with drill bit. Glass is seated
approximately 1/2" into channel.
C
J
Side Panel
INSIDE OF SHOWER
Join corner posts to sill by drilling, from outside
of shower, through sill into corner posts. Holes
should be 1/2" from corner joining on panel
side of corner posts. Secure using 8A x 3/8"
truss head screws.
Door Panel
Side Panel
When securing corner posts, do not hit
glass with drill bit. Glass is seated
approximately 1/2" into channel.
Side Panel
8A x 3/8" Truss
Head Screws
OUTSIDE OF SHOWER
J
Sill
A
B
Jamb
B
Jamb
D
Corner Post
D
Coner Post
D
Corner Post
D
Coner Post
12
Header
(C)
13
Securing Corner Posts
Mount interior and exterior pull handles, from
pull handle kit (Z), onto door panel using
6-32 x 1 1/4" pan head screws provided.
Screw heads should be on the inside of
shower.
6-32 x 1 1/4" Pan
Head Screw
Interior Handle
Exterior
Handle
OUTSIDE OF SHOWER
Pull
Handle
Kit
Handle for your door may be pre-installed. If
so, disregard this step and continue installation.
Z
14
Pull Handle Kit
(Z)