Installation instructions – Coral Industries Provincial Prestige Swing Door - 4PJ User Manual
Page 2
4PJ 8/02
Before starting installation of your new enclosure, carefully read all
instructions and lay out parts to become familiar with their identity.
Do not try to cut the mirrors or glass used in this enclosure. • Tempered glass and mirrors will disintegrate if cut.
CLEANING
Cleaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal and
bath meet. If desired, caulk inside of enclosure where jambs meet walls.
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure to a
fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with a 1/8" drill
bit.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes in the
tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors into the holes
making certain that ring on large end of anchor meets the surface of the tile.
USE OF ANCHORS
INSTALLATION INSTRUCTIONS
Measure opening at threshold of shower and cut sill (A)
to exact measurement. If necessary, file sharp corners to
fit contour of your unit.
Position sill on center of threshold with tall edge of sill
toward outside of shower. Tape sill to threshold with
masking tape to hold in place while positioning jambs.
Measure
OUTSIDE OF
SHOWER
Threshold
Centerline
Masking Tape
Sill
A
File sharp
corners as
necessary to
fit contour of
your unit
OUTSIDE OF
SHOWER
Place jamb (B) on sill with short legs against wall. Align
vertically on wall using a level. Mark wall through pre-
punched holes. Remove jamb and drill where marked using
1/8" drill bit.
If necessary, file sharp corners on back of jambs to fit
contour of your unit.
Reposition jambs on wall and secure using 8A x 1" pan
head screws (G).
2
Level
Sill
A
Contour as
needed
Jamb
B
1
Due to the manufacturing process,
there may be rack marks present at
one end of your sill. All sills must be
trimmed to fit individual openings.
When cutting sill, make certain to
trim off end with rack marks.
Centerline
OUTSIDE OF SHOWER
8A x 1" Pan
Head Screws
G
When anchors (H) are used, holes
should be drilled using 3/16" drill
bit. (Use masonry bit for tile.)