Carson Optical 1181281 - Manual (Page 6)

6
6. Install video system wiring into vehicle. Route video
system cables from installed position in center of roof to
“B”-pillar. Down “B”-pillar to floor. Route power and
ground leads forward to fuse box area. Connect power wire
to a fused accessory controlled power source per
instructions provided in video system. Ground negative lead
to chassis. Route remaining wiring (RCA plugs, Remote
sensor extension, etc.) to VCP location. Connect per
instructions provided with video system. If video system is
to be used as a television, install an appropriate antenna per
instructions included with antenna. See Figure 7.
III. PREPARATION OF OVERHEAD CONSOLE.
1. Remove and retain OEM front control head bezel
assembly by removing four ( 4 ) screws. See Fig. 8.
2. Remove and retain secondary light and pod assembly by
removing eight ( 8 ) OEM screws. See Figure 9.
Figure 7
Figure 8
Figure 9