Coral Industries Freestyle Bypass (1/4 Frameless) - 2FG1-P (If Purchased from a Plumbing Wholesaler) - Manual (Page 5)

2FG1P 11/05
Measure from wall to wall (over the top of both jambs)
and cut header (C) to that measurement.
Lower header over jambs until seated squarely on legs
of both jambs.
4 Header
(C)
Header
C
Jamb
B
Measure
Sill
A
Jamb
B
Jamb
B
To mount top channel/roller fin (M), align fin with top of
glass and mark through holes in glass. Using 1/4" drill
bit, drill fin where marked so that holes in roller fin
match holes in glass. Secure fin to glass with plastic
post (N) and 10-32 x 3/8" pan head screw (O)
provided.
Some units come with top channel/roller fin pre-
installed on door panels. If pre-installed on your
unit, proceed to next step.
Post
10-32 x 1/4"
Pan Head Screw
M
Top Channel/Roller Fin
N
O
5 Roller Fin
(M)
Towel Bar Kit
Towel Bar
Round
Bushing
Plastic
Washer
E
Towel bars are to be mounted onto door panel through
predrilled holes in glass. Towel bar for outside panel
faces outside of bath while bar for inside panel faces
inside of bath.
Towel bar kit comes with parts assembled in the order
they will be installed on glass. Disassemble parts.
Press bushings into holes in glass. Trim as needed so
that bushings are flush with surface of the glass.
Reassemble towel bar, plastic washers, and end cap
on door panel as shown. Tighten both end caps evenly.
Allen wrench may be used to aid in tightening by
inserting into hole of end cap and turning. Repeat for
remaining door panel.
End Cap
6 Towel Bars
(E)
Towel bar for outside panel
faces outside of bath while
bar for inside panel faces
inside of bath.
OUTSIDE OF BATH