Coral Industries Style Bypass (3/16 Frameless) - 20R1-P (If Purchased from a Plumbing Wholesaler) - Manual (Page 5)

20R1-P 7/05
Measure from wall to wall (over the top of both
jambs) and cut header (C) to that measure-
ment.
Lower header over jambs until seated
squarely on both jambs.
Attach header to jambs by drilling a 1/8" hole
through header into jambs on inside of tub
near walls. Secure using 8A x 3/8" truss
head screws (L).
Measure
Jamb
8A x 3/8"
Truss Head
Screw
L
Sill
A
Jamb
B
Jamb
B
B
4 Header
(C)
INSIDE OF SHOWER
Header C
Door
Bracket
Towel Bar
Bracket
Bracket
Sleeve
8A x 1"
Flat Head
Screw
E
E
Slide bracket sleeves from towel bar bracket kit (E)
onto towel bar brackets. Mount towel bar brackets
onto metal door brackets using 8A x 1" flat head
screws.
5 Towel Bar Bracket Kit
(E)
Measure full height of glass and determine the midpoint.
At midpoint, wrap one piece of bracket vinyl (E) around
door glass, holding in position while slipping one door
bracket assembly in place over vinyl. Insert towel bar (D)
onto end of towel bar bracket. Slip door bracket assembly
in place for opposite end, inserting bracket into end of
towel bar. Repeat for remaining panel.
Door
Bracket
Assembly
Bracket
Vinyl • Towel bar for outside panel faces outside of shower, while
towel bar for inside panel faces inside of shower.
• There are two thicknesses of bracket vinyl included with your
unit. When positioning brackets on glass, use the vinyl that
makes a snug fit between door bracket and glass.
6 Towel Bar
(D)
/ Towel Bar Bracket Kit
(E)
Towel Bar D
E
E
OUTSIDE OF SHOWER