Cuddeback EXPERT - Manual (Page 17)

a. Press numerous times. The “(“ will
change and continue to change as is
pressed. Keep pressing to see all the
available characters.
b. Once the character you want is displayed,
press to advance to the second posi-
tion. A 0 will be displayed.
c. Press to change the second character.
Continue to press until the character
you desire is displayed. Then press
to advance to the next position.
d. Continue repeating step c until you have
completed entering the text you desire.
e. Enter up to 16 characters that you desire
using this method.
f. After you have entered the text you desire,
press . [Saved!] will be displayed and
the text you entered will be saved in
Cuddeback's memory (
figure 49 ).
TIP - You don't have to enter char-
acters in all 16 positions. At any
time you can finish by pressing (C).
You can cancel entering the phone
number at any point before Saved!
is displayed by pressing (S)
32
Saved!
Figure 49
If you make an error while entering the phone number and need to back up to the pre-
vious position to correct the error, you can follow these steps.
1) After you press the display will advance to the next position and the character <
will be displayed.
2) If you made an error and want to return to the prior position, press when < is
displayed.
3) If the < character is not displayed, press until < is displayed. Using this
method, you can back up all the way to the start if required.
TURNING THE FLASH ON OR OFF
Cuddeback allows you to turn off the built in flash.
You can select Auto or Off. When Auto is selected,
Cuddeback will use the flash if needed. This is the
recommended setting. When Off is selected,
Cuddeback will NOT use the flash, therefore
images that require the flash will NOT be taken.
Daylight images will always be taken.
1) Press numerous times until [Camera
Setup? C = Yes] is displayed ( figure 50 ).
2) Press .
3) Press numerous times until [Flash
Mode] is displayed ( figure 51 ).
4) Press or to change the setting.
SETTING THE FLASH POWER
Cuddeback's built-in flash has two flash settings:
Battery or distance. The battery setting will pro-
vide longer battery life but will have less range.
The distance setting will provide a greater flash
range but battery life will be reduced.
1) Press numerous times until [Camera
Setup? C = Yes] is displayed.
2) Press .
3) Press numerous times until [Flash Best
For] is displayed ( figure 52 ).
4) Press or to change the setting.
33
Flash Mode
Auto
Figure 51
Flash Best
For
Figure 52
Camera Set
C = Yes
Figure 50
Expert07OwnerManualReader.qxd 11/6/07 3:39 PM Page 17