Dave Smith Instruments PROPHET 12 DESKTOP - Manual (Page 22)

10 Global Settings Dave Smith Instruments
For example, the Resonance parameter has a value range of 0 to 127. Let’s say
the physical position of the Resonance pot is the equivalent of a value of 100.
If you switch to a program that has a stored Resonance setting of 63 and turn the
pot all the way up, it will only go to 90. To get to the maximum value of 127, you
first have to turn down until the value is at the other extreme and the pot is at the
limit of its travel (in this case, 0 and fully counter-clockwise, respectively).
In Passthru mode, turning the pot has no effect until after the edited value equals
the preset value (that is, until the edited value “passes through” the stored value).
Jump mode uses an absolute value based upon the position of the pot when
edited: turn a pot and the value jumps immediately from the stored value to the
edited value.
16 . Sustain Footswitch: Normally Open, Normally Closed— There are
two types of momentary footswitches, normally open and normally closed. Either
type can be used with the Prophet 12’s Sustain switch input. Not sure which type
you have? If the footswitch’s behavior is the opposite of what’s expected—that
is, down is off and up is on—changing this setting will correct that.
17 . Sustain Pedal Function: Sustain, Arp On/Off— The footswitch can be
used for sustain or to turn arpeggiator hold on and off.
18 . Pedal 1 Function: Breath Control, Foot Controller, Expression,
Master Volume, Lowpass Filter: Full Range, Lowpass Filter: Half
Range— Sets the function/destination for the Pedal 1 input. An expression pedal
can be routed to any destination using the modulation matrix. See Modulation on
page 32 for more information.
19 . Pedal 2 Function: Breath Control, Foot Controller, Expression,
Master Volume, Lowpass Filter: Full Range, Lowpass Filter: Half
Range— Sets the function/destination for the Pedal 2 input. . An expression
pedal can be routed to any destination using the modulation matrix. See Modula-
tion on page 32 for more information.
20 . Basic Patch— Press Write Now (soft key 1) to load a basic, template
program into the edit buffer. Use W
rite
to permanently save any changes to
memory.