Installation – Dynojet 250: Throttle Stop User Manual
Page 2
Advertising
2
Document #98220102
Dynojet Technical Support 1-800-992-4993
Installation
Step 1
Install the Throttle Stop by sliding it over the
Motorcycle’s handlebar grip.
Loosen the “Fine Adjustment Knob” on
the “Throttle Stop” and rotate it to it’s full
counter clockwise position.
Orient the aluminum “Throttle Stop” so
that the “finger” is under the brake lever.
Warning:
The throttle stop should installed while
the motorcycle is NOT RUNNING and
the ignition switch in the OFF position!
Note:
Become familiar with the “Throttle Stop”
operation before attempting to use it in
conjunction with your Dynojet
Dynamometer.
Fine Adjustment
Knob
Advertising
This manual is related to the following products: