Dynojet 250i: Motorcycle Exhaust Extraction System Drawings - Manual (Page 17)

11/15/2004
DESIGNED:
APPROVED:
CREATED:
UNLESS OTHERWISE SPECIFIED:
TOLERANCES
DECIMAL
0.1
0.03 X.XX ±
0.010
FRACTIONAL
± 1/16
ANGULAR
X.XXX ± °
DO NOT SCALE THIS DRAWING
DYNOJET RESEARCH, INC. 200 ARDEN DRIVE, BELGRADE MT 59714
± Latch Mount Half
SCALE: RELEASE DATE: SHEET OF
REV PART NO. SIZE
A
LatchMount
ALL IDEAS, DESIGNS, ARRANGEMENTS AND PLANS INDICATED OR REPRESENTED BY THIS DRAWING ARE OWNED BY
DYNOJET RESEARCH INC. AND WERE CREATED, EVOLVED AND DEVELOPED FOR USE ON AND IN CONNECTION WITH
THE SPECIFIED PROJECT. NONE SUCH IDEAS, DESIGNS, ARRANGEMENTS OR PLANS SHALL BE USED BY OR DISCLOSED
TO ANY PERSON, FIRM, OR CORPORATION FOR ANY PURPOSE WHATSOEVER WITHOUT THE
DYNOJET RESEARCH, INC.
NOTES, UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS ARE IN DECIMAL INCHES.
REMOVE ALL BURRS & SHARP EDGES.
REMOVE ALL TOOLING MARKS.
DIMENSIONS & TOLERANCES SHALL BE HELD
AFTER PLATING OR FINISH. 1.
2.
3.
4. APPROVED DATE ECR# REV DESCRIPTION
REVISIONS
WRITTEN PERMISSION OF DYNOJET RESEARCH, INC.. 1 1 1:12
KAN
LAST UPDATE:
MATERIAL:
FINISH:
KAN
2" x 2" x 1/8" Steel Angle
14312000, GLOSS BLACK POWDER COAT
NR
MC Exhaust Extraction
FOR QUOTING OR
PROTOTYPE ONLY
SHOULD BE OBTAINED FROM THE MODEL.
NOT RELEASED
SHOWN ARE FOR REFERENCE, ANY OTHER DIMENSIONS
DATA FILE PROVIDED TO THE VENDOR. DIMENSIONS
THIS PART IS PRODUCED FROM AN ELECTRONIC
UNRELEASED!
X.X ±
11/15/2004
1.563
11.938
.375
.435
3.435 3.435
.435
.500
Thru
(2 plcs.)
.250 Thru
(2 plcs.)
2.000
2.000