Dynojet Optical RPM Sensor - Manual (Page 21)

O P T I C A L R P M S E N S O R I N S T A L L A T I O N
Running WinPEP
Optical RPM Sensor Installation Guide
1-15
3 Stop the vehicle.
3a
Remove your foot from the accelerator pedal.
3b Take the vehicle out of gear (manual transmission only).
3c Press brake button on the hand-held pendant to stop the dyno drums.
Do NOT use the vehicle’s own brakes to slow the dyno drums! Using only the
vehicle’s brake to stop the drums will severely over stress the vehicle’s brake
parts. The vehicle’s brakes should be used in emergency stop situations only.
3d Shut the engine off.
3e Put the vehicle in gear (manual transmission) or park (automatic
transmission).
3f Set the vehicle’s emergency brake. Leave the dyno brake on.
4 Check the straps.
4a
Make any adjustments to the straps that may be needed.
4b Verify the drive tire’s alignment on the dyno drums.
4c Perform any other safety checks that you deem appropriate to your
particular situation.
You are now ready to perform a high speed run on the dyno.