Wiring the sensor – Dynojet Tire Temperature Sensor User Manual
Page 8
Advertising
Tire Temperature Sensor Installation Guide
T I R E TE M P E R A T U R E S E N S O R
Installation
4
W
IRING
THE
S
ENSOR
1
Remove the hood from the dyno.
2
Attach the five wires on the cable coming from the tire temperature sensor to
TEMP on the Breakout board as described below.
• Green wire to G2
• White wire to W2
• Black wire to B2
• Red wire to R2
• Silver (ground) wire to S2
Note: Do not use G1 through S1. These are reserved for monitoring the brake
temperature.
Figure 4: Wiring the Sensor
TEMP
sensor cables
Advertising