Dynojet Analog Module - Manual (Page 11)

A N A L O G M O D U L E I N S T A L L A T I O N
Analog Module Installation
Version 1 Analog Module Installation and User Guide
1-7
C ONNECTING THE S ENSOR C ABLES
1 Attach the sensor cable(s) to the Analog Module cable assembly. The two types of
sensor cables are described below and shown in Figure 1-6.
• An unterminated sensor cable, included with your Analog Module, is designed
to connect directly to or “tap into” the vehicle’s existing sensors. Wire the
cable as follows:
• Red is 5 VDC
• Green is sensor output
• Black is GND
• A terminated sensor cable is designed with a specific sensor attached for
measuring a specific pressure.
2 Once the sensor cable is connected to the analog cable, you will need to route the
sensor cable to the appropriate location on your vehicle for the pressure you are
measuring.
Figure 1-6: Attach the Sensor Cable(s) to the Analog Module Cable Assembly
3 Attach the power cord to the CPU Module and turn the dyno electronics power
switch on.
4 Connect all power to the dyno.
5 The green LED light on the Analog Module should now be on.
6 Replace the dyno electronics cover. Refer to Figure 1-1 on page 1-3.
connect to
analog module
analog module cable assembly
unterminated sensor cable
terminated sensor cable
red
green
black