Dynojet Data Link Module - HD Delphi ECM - Manual (Page 11)

D A T A L I N K M O D U L E - H D D E L P H I E C M
DJ-DLM Set Up
Version 1 Data Link Module - HD Delphi ECM Installation and User Guide
7
T ROUBLESHOOTING C ONNECTION E RRORS
If you do not see the Device Connected - Communicating with the ECU, check to see
that you are not experiencing one of the following problems:
If you still cannot establish connection between your DJ-DLM so that it is
communicating between the software and the bike’s ECU, call Dynojet Technical
Support at 1-800-992-3525 for personal assistance.
Problem TRY THIS THEN THIS
Device Not
Connected
Verify that USB cable is
plugged into computer
and is making
connection.
Verify the DJ-DLM is plugged
into the bike’s data port. This
occasionally may appear to
“snap” into place, but may not
be making connection.
Error
Communicating
with ECU
Verify that bike power is
turned on and if there is a
ready to start switch it is
turned on. If necessary
start the bike.
Recheck the plug end to the
bike’s data port. This
occasionally may appear to
“snap” into place, but may not
be making connection.