Dynojet Wideband Commander Air/Fuel Ratio Monitor - Manual (Page 4)

I15-7012 Wideband Commander Air Fuel Ratio Monitor Installation Guide - 2
5 When using the compressed air setup to run
the main air fuel ratio, remove the O2 sensor
bung plug in the sensor block.
6 Install the Wideband Commander O2 sensor in
the block along side the sensor that is already
there.
Note: The procedure is the same for the stand-
up compressed air.
7 Connect the USB cable to the mini USB port
on the Wideband Commander.
8 Connect the USB cable to an available USB
port on your dyno computer.
C ONFIGURING THE S OFTWARE
The Wideband Commander must be plugged into
the USB port, the power cable must be plugged
into the wall, and the O2 sensor must be wired
into the Wideband Commander module.
1
Open WinPEP 7.
2 Select Tools ! MakeRun Options
! MakeRun Configuration.
3 Click the Expansion Ports tab.
4 Enable Wideband Commander.
5 Click OK.
6 Click the Edit Mode button . You cannot
edit gauges unless you are in Edit Mode.
The gauge toolbar will appear.
7 Click the Vertical Bar Gauge button .
8 Click and drag, holding the mouse button
down as you do so, on the MakeRun panel
until the dotted box is the desired size. Release
the mouse and the gauge will appear.
9 Right click on the gauge and choose Gauge
Properties.
The Gauge Property Editor dialog box will
appear.
10 Select WBC AFR from the Data Channel drop
down list.
11 Set the Min to 10 and the Max to 18.
12 Click OK.
You are now ready to monitor dual air fuel
ratios simultaneously.
Fi
gu
re
C
Fi
gu
re
D
Fi
gu
re
E
edit mode gauge toolbar