Dyras WHT-210 - Manual (Page 4)

EN
WHT-210 WHT-210
6 7
break. The manufacturers’s warranty does not cover damage due to improper use, or damage caused as a
direct result of non-observance of the instructions given in the operating manual.
• Never allow the mains cable of the appliance to trail near sharp or hot objects. Ensure that the cable is unable
to come into contact with the appliance front cover during use.
• Warming! Certain parts of the appliance get hot during operation so avoid touching the appliance,
accidentally or otherwise, when it is switched on, or before it has completely cooled down, except to operate
the switch.
• The mains plug of the appliance must always be disconnected from the wall socket or extension cable after
use, and before cleaning. Never remove the mains plug from the socket by pulling its cable, always grip the
plug! Always switch off the appliance before removing the mains plug from the wall socket.
• Modifying or adding an extra length to the power cable of the appliance is forbidden!
Should the cable of the appliance turn out to be too short, it may be extended only by using a commercially
available standard extension cable equipped with protective earth contact, and the extension cable must
have an electrical rating of at least 10 A (cables with lower electrical rating could heat up during use). If
other electric appliances have to be operated simultaneously with the same extension cable, their current
consumptions must be added up to determine the electrical rating requirement of the extension cable. If an
extension cable is used, both the mains socket and the extension cable must have protective earth. When an
extension cable is used, special care must be taken to avoid tripping over it.
• You must not disassemble the appliance, remove its cover or to try to repair it. Ignoring this advice could cause
a serious accident. There are no parts in the appliance that can be repaired at home or used for any other
purpose. Never operate the appliance with a damaged mains cable or connector. Do not use the appliance if
it fails to work normally or if it has been dropped or damaged. If the appliance becomes faulty for any reason
or if any moisture is allowed inside, take it to an authorised service engineer for checking and repair. Only
service engineers who have been trained and approved should repair the appliance. The manufacturer cannot
take any responsibility for unauthorised repairs or for any circumstances resulting from not following the
instructions.
Dear Customer,
all electrical and mechanical equipment needs to be cared for appropriately. It’s important to note
that using or storing the appliance in certain conditions may adversely affect its lifespan and func-
tionality. always protect the appliance from the conditions listed below.
Using or storing the appliance in a wet, humid or damp environment can cause:
– deterioration and premature aging of the cover and electric insulation of the appliance,
– premature wearing and aging of the plastic and rubber components,
– rust and corrosion affecting electrical components and metal parts.
Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapours from cooking oil or grease) can cause
– greasy dust coatings on the mechanical and electrical elements and the casing of the
appliance, which could result in electrical contact failure or even complete breakdown, and
could also damage the plastic and rubber elements.
The effects of direct sunlight on the appliance can include:
– accelerated deterioration of the appliance casing and its plastic and rubber components,
damage to strength and other structural features. The appliance’s surface may become porous
and fragile, which may result in a safety risk.
Continuous heavy duty use may cause:
– premature structural wear and tear and premature aging of the motor due to extensive use of
the appliance, resulting from wear and tear and overheating due to continuous use.
storing the appliance in cold or frosty environment may cause:
– damage to the plastic and rubber components; if they become fragile, this may result in a
safety risk.
– oxidation resulting from condensation, and corrosion of the metal components.
following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the appliance. The manufacturer is not responsible if the appliance is stored
inappropriately or contrary to these instructions. you are recommended to have the appliance
serviced regularly by an authorised engineer to keep it working for as long as possible.
Please respect the environment when the appliance reaches the end of its life. Electrical products
must not be disposed of with other residential waste because they can damage the natural world and
may be hazardous to human health. You should dispose of the appliance at an appropriate recycling
site or by using a collection service that specialises in electrical appliances.
Please keep this instruction manual. If you give the appliance to anyone else, you must give them this
instruction manual, too!
maIN CompoNeNTs
1. Heating level switch with pull cord (stages 0, 1 and 2)
2. Upper heating element
3. Lower heating element
4. Tilting heating unit
5. Protective grille
6. Fixing support for the appliance
7. Mains cable and connector (not seen on the picture)