Dyras BSM-588 - Manual (Page 5)

POWER SUPPLY
The device must only be connected to mains electricity of 230V and 50Hz. Always ensure the
mains voltage where you’re using the device corresponds to the value shown on the nameplate of
the device.
USING THE DEVICE
BEFORE USE
• Unpack the device and remove all the packing materials.
• Carefully check the device to ensure it is complete and undamaged. You should only use the device if it is
complete and has not suffered any damage.
USING THE MASSAGE DEVICE
1. Choose the appropriate adapter:
- the wave adapter can be used for fat burning or for reducing the appearance of stretch marks and/or
cellulite. You can use this in conjunction with special fat burning or firming cream to increase the effect.
- the roller adapter helps to tighten slack skin and relax tired muscles.
2. Fix the chosen adapter on the adapter socket.
Always use the protecting adapter if you are massaging your neck, shoulder or any
other place where the device could touch your hair.
Using the protecting adapter on the front edge of the device will prevent your hair
from being trapped.
BSM-588
8
3. Connect the mains plug of the device to the wall socket. Turning the control button in a clockwise direction
will switch the device on.
4. The speed of the rotating/vibrating head, which affects the intensity of the massage, can be reduced or
increased by turning the control button.
5. We do not recommend using the device on the same part of the body for more than 15 minutes in any
session.
6. To switch off the device, turn the control button in an anticlockwise direction until it clicks. You should then
remove the mains plug from the wall socket.
MAINTENANCE AND CLEANING
Before you clean the device it must be switched off and the mains plug must be
removed from the wall socket.
• Clean the outside cover of the device with a damp, soft, lint-free cloth and then wipe the cleaned surfaces
with a dry lint-free cloth. Take care not to allow any moisture inside the cover. Let the device dry completely
before re-using or storing it.
• The massage adapters and the protecting adapter can be washed with a soft, neutral detergent under tap
water. They should then be rinsed and left to dry.
• Never use solvents (acetone, benzene, petrol etc.) to clean the device because these materials could dissolve
the plastic cover and damage the internal components. Do not use harsh or abrasive cleaning agents.
• If you don't plan to use the device for a while after cleaning it, place it in a nylon bag and store it in a place
that is free from dust, damp and frost. Do not wrap the mains cable around the device when storing it
because the insulation can deteriorate or break under these circumstances.
EN
BSM-588
9
User'sManual BSM-588_A5:User's Manual for BSM-588 2010.04.13. 14:25 Page 8