Eden DC-210XLT Metro - Manual (Page 11)

11
Setting Your Level – Remember, begin with the Input Gain, Enhance,
Compressor and Master Volume completely OFF – fully counter-clockwise.
All EQ should be set flat, that is, at 12:00 – straight up.
While playing your lowest note (or loudest), slowly turn the Input Gain up
until the Set Level light begins to blink with regularity. If you can’t go past 8
or 9 o’clock, you may engage the Gain Switch to better match the gain of
your instrument to the amplifier.
If you have disengaged the Compressor as we suggested, the Set Level light
will barely blink on your loudest notes. By the way, this is David’s favorite
way to set level, even if you intend to use compression.
Once you have properly set your Input Gain, turn the Master Volume up to a
comfortable listening level and proceed with the rest of the setup process.
Setting the Compressor - If you want to use compression, engage it now by
turning the Compressor Defeat switch OFF. The compressor light will now
blink when your gain goes above the compression threshold. This will
generally show up more on the lower notes, or when you employ Slapping.
(A properly compressed Slap sound is very cool, indeed.) If you want more
compression, increase the Input Gain a little at a time, until you achieve the
amount of compression you desire.
SETTING YOUR EQ
The frequencies that you’ll need to boost or cut are dependent upon your
instrument, playing style, speaker cabinets, and venue. Extreme settings of
boost or cut are unlikely to be necessary or helpful. We are frequently asked
to provide suggested settings for various styles of play. We have discovered
though, that most of our endorsers tend to set their EQ generally flat, using
varying amounts of the Enhance Control to achieve their sound. In fact, a
number of our recording artists tell us that their standard recording set-up is
to have the Enhance set at approximately 9 or 10 O’clock and the tone
controls set flat.
We encourage you to experiment with different settings to obtain the sound
you desire. We have included some EQ panel diagrams at the back of this
manual to help you record your settings.