Eden DC-210XLT Metro 2003 - Manual (Page 8)

8
This control works just like the midrange control with +/- 15 dB of change
available. It regulates frequencies between 1.2 KHz and 12 KHz. This control is
very effective for bringing out the bright overtones on the bass.
E.Q. Clipping Indicator
This LED will light up if the signal is clipping any place in the tone control or Pre-
amp section. If this lights up while you are playing it will be necessary to redesign
your tone controls or lower you input gain to prevent signal distortio n.
Master Level Control
This control is directly ahead of the output power amplifier. It controls the main
stage sound level and the Head Phone outputs.
Head Phones
The Head Phone jack is provided for practicing and can be used as an additional
signal send or slave output as it follows the Master Control.
Internal Speaker Switch
This turns on and off the internal speaker in the enclosure. It does not turn off the
External speaker Jacks, they will always be connected to the amplifier.
Mains AC Power Switch
This turns your unit on and off. Due to the international voltage selector that your
unit is equipped with the AC Mains power switching is placed ahead of the fuse. It
is possible for the fuse to be blown and the indicator light to be on. It is set up that
way to meet certain European Safety regulations. Always be certain the unit is
properly set up for the correct voltage of the country it is being used in. If you have
any questions about this, call either the factory or an authorized service center and
find out before you attempt to use your unit. If you need to change operating
voltages for international travel call ahead and make certain that you know the
voltage and line cord required by the country you will be going to. Always have a
qualified technician do the voltage changes.
The Back Panel Operation