Eden N10 - Manual (Page 4)

4
GAIN CONTROL
This control regulates the first amplification stage and controls the gain of the
first stage in the overall system. The compressor automatically tracks the input
level and follows the gain. This is a fixed-threshold type compressor. You
control the compressor threshold by setting the gain higher or lower; depending
on how much compression effect you want. The compressor is also provided
with a bypass switch to defeat the compressor operation if desired. For most
instruments, you should set the control between 9:00 and 3:00 to match your
instrument and playing style to the amplifier.
HEADPHONE OUTPUT/ Aux. Line Out
This jack provides the output for headphones for practicing. If you switch off
the internal speaker, you can use your amplifier to rehearse with just the
headphones. It can also be used as an Aux. line level output to run additional
amplifiers. This output will function as the final master control and the
additional amplifiers will be slaved to it.
D.C. INDICATOR
This indicates that both the D.C. power supplies are operating properly and the
amplifier is turned on.
BACK PANEL FEATURES
A.C. FUSE
The fuse for US operation is a 2.5 Amp. 5x20 MM slow-blow type fuse. In
Europe, use a 1.2 Amp or 1.6 Amp 240v slow-blow fuse and the appropriate
AC connector for your country. Make certain that your unit is set for the
correct voltage for your country.
VERY IMPORTANT NOTE: The unit is set at the factory to operate at the
correct voltage for your country. It cannot be changed.