Eden WP 100 Navigator (2006) - Manual (Page 8)

8
USE ONLY THE SAME SIZE AND TYPE FOR REPLACMENT.
Using a fuse with a different rating than specified is a VERY BAD
THING and can cause damage to your amplifier. All models come with a
holder marked (FUSE) or (115/230) and are factory configured for 100/120/
230/240 only and must be adapted by a service tech for any voltage change.
Fuse Requirements:
USA @ 120 Volts /60 HZ – 1 Amp, 5 x 20 mm GMC/T/slow blow
Europe @ 240 Volts/50 Hz – 0.5 Amp, 5 x 20 mm GMC/T/slow blow
IMPORTANT NOTE: Always use slow blow or time delay type fuses.
Do not use fast blow fuses.
To convert your amplifier from US to European fusing, remove the Fuse
Holder and insert a 0.5 Amp slow blow fuse. Flip the fuse holder over and
reinsert.
IMPORTANT NOTE: In order to operate properly in parts of the
world not listed above, your amplifier may require minor modifications
in addition to a different value fuse. These modifications must be made
by a QUALIFIED technician. Contact your local distributor for further
information.
Aux. Input - This standard 1/4-inch input jack is designed to accept the
signal from an external source such as a CD or cassette player, drum
machine, synth. module, etc. The signal is summed (added in) prior to the
tone controls and Master Volume control. This jacks can also be used to
return a studio cue signal, allowing the Navigator to provide you with your
own headphone mix in the studio. The Aux signal is summed with the main
input and sent to all outputs, including the DI.
Stereo Post-EQ Effects Send/Return – These standard 1/4-inch jacks allow
you to send and receive your signal to and from external devices. This
effects loop is positioned post (behind) the tone section. This loop is at line
level; do not use instrument level effects in this loop as they tend to be
overloaded by the higher signal level which can cause distortion. To use
with mono effects, return the signal to the Left return.