Eden WP100 Navigator (2011) - Manual (Page 10)

10
Stereo Post-EQ Effects Send/Return – These standard 1/4-inch jacks allow
you to send and receive your signal to and from external devices. This
effects loop is positioned post (behind) the tone section. This loop is at line
level; do not use instrument level effects in this loop as they tend to be
overloaded by the higher signal level which can cause distortion. To use
with mono effects, return the signal to the Left return.
Tuner Out Jack – This standard 1/4-inch jack is designed to provide a pre-
gain signal for connection to a tuner. It can also be used to provide pre-tone
signal to other devices such as a direct box or console. The signal is enough
to provide adequate signal to virtually every tuner on the market.
FOOTSWITCH FEATURES
Your Navigator comes with its own footswitch, allowing you to make
changes on the fly while playing. All corresponding panel switches take
priority over the footswitch. The following functions can be controlled by
the footswitch:
x Mute to Tune
x Compressor Defeat
x Enhance Defeat
x Turbo Boost
OPERATING INSTRUCTIONS
Mechanical and Thermal Issues – During operation, your amplifier should
always be placed away from sources of moisture or heat. The supplied rack
ears can be used to install your amplifier in a conventional equipment rack
for protection during transportation.
Connections – Output connections should be made using balanced or
unbalanced cables. Unbalanced cables are fine for short runs, but for longer
runs, you should use balanced cables. All instrument-level input connections
(Effects Loops, etc.) should be made with high quality shielded cables. The
use of speaker cables for input connections will result in excess noise.