Eden WT1250 - Manual (Page 9)

9
Connections – Line connections (everything but the speakers) should be
made with high quality shielded cables. The use of speaker cables for line
connections will result in excess noise. Speaker connections should be made
with high quality 16 gauge or larger unshielded speaker cables. We
recommend 10 or 12 gauge cables. The use of shielded line or instrument
cables for speaker connections can damage your amplifier. The speaker
cable should be as short as possible.
To operate your unit in Dual Mono mode, connect the signal from your
preamplifier to Channel One; using the Mode Selection switches on the front
panel, select Dual Mono mode. In this mode, both amplifiers will receive the
same signal. Connect the appropriate speaker cabinets to the outputs from
both amplifiers.
To operate your unit in Stereo mode, connect Left and Right signals from
you preamplifier to the appropriate channels; using the Mode Selection
switches on the front panel, select Stereo Mode. Connect the appropriate
speaker cabinets to the outputs from both amplifiers.
To operate your unit in Bridge Mono mode, connect the signal from your
preamplifier to Channel One; using the Mode Selection Switches on the
front of the unit, select Bridge Mono mode. Connect the appropriate speaker
cabinets to the Bridge Output ONLY. Do not connect speakers to the
individual amplifier outputs in this mode.
WARNING: Never, and we mean NEVER, connect the two individual
amplifier outputs to the same speaker cabinet, especially in Mono
Bridge Mode. If you do, you may damage the ampifier &/or speakers.
NOTE: Always select the operation mode while the amplifier is OFF.
DO NOT change modes while the unit is ON. If you want to change
modes, turn the amplifier OFF first.
IMPORTANT NOTE: Before you plug in your unit for the first time,
please do the following things. First, turn the power switch to the OFF
position. Check the back of your unit for the correct voltage notation for
your county of operation. Check all connections to make sure you’ve
connected everything properly. Ensure that the Mode Selector switches are
in the correct position for your chosen mode of operation. Failure to follow
these steps may cause damage to your amplifier.