Eden WT550 - Manual (Page 5)

5
Semi-Parametric Controls
There are three sets of semi-parametric controls. Each set has a Frequency
control (top knob) and a Level control (bottom knob). The Level controls
provide 15 dB of cut or boost. The control is FLAT in the 12:00 position.
From left to right, the Frequency controls have the following ranges:
30-300Hz
200Hz-2KHz 1.2-12KHz
Treble – This traditional shelving tone control provides 15 dB of boost or
cut at approx. 11KHz. The control is flat in the 12:00 position.
EQ Clip Light – indicates clipping in the EQ section. Clipping is a Very
Bad Thing and should be avoided at all times. We’ll tell you how to avoid
this later in the manual.
Master Level Control – Adjusts overall system output and stage loudness.
Headphone Jack – Accepts a standard ¼ inch stereo or mono headphone
plug. It can also be used as a Master Output send to slave another amplifier.
Output Limit Indicator – Lights to indicate activity of the power amplifier
limiting circuit, which protects the speaker system from severe distortion.
These LEDs indicate that the amplifiers have reached their maximum output
level.
Mains On/Off Switch – This switch turns the system power ON or OFF.
The switch illuminates to indicate the presence of AC power present in the
chassis. This switch is prior to the fuse. The light in the switch may flicker
depending on local voltage conditions. This is normal and nothing to be
concerned about.
NOTE: The Mains Switch will illuminate even if the fuse is blown.
REAR PANEL FEATURES
Amplifier Power Rating (RMS with +3dB headroom):
300 Watts @ 8 Ohms
550 Watts @ 4 Ohms
750 Watts @ 2 Ohms