EFCO 2 1/2" Center Tongue Sun Shade Clip - Manual (Page 6)

SERIES 5600 CENTER TONGUE SUNSHADE CLIP INSTALLATION MANUAL 6/2012
EFCO CORPORATION PART #YWSS Page 6 of 19
SECTION III: SUNSHADE PRESSURE PLATE
ATTACHMENT
Locate the sunshade pressure plate and install with all the adjacent pressure plates. It is crucial that the sunshade
pressure plate be located properly. Half of the pressure plate height will be the centerline for the sunshade clip.
The sunshade pressure plate is 15” in length. Fasten the sunshade pressure plate with the appropriate fasteners
as recommended (Based on structural review and shop drawings). It is recommended to leave 1/8” to ¼” gap
between the sunshade pressure plate and the adjacent vertical pressure plate. This gap will be sealed with
silicone.
SUNSHADE CLIP LOCATION: THE
SUNSHADE ATTACHMENT DOES NOT
NECESSARILY OCCUR AT THE
HORIZONTAL MULLION LOCATIONS.