Elecraft KX3 Assembly Manual Errata - Manual

Page 1 of 5
K X 3 K I T A S S E M B L Y M A N U A L E R R A T A
R e v . G 5 - 1 , D e c e m b e r 1 0 , 2 0 1 4
M A K E T H E S E C H A N G E S T O Y O U R R E V G 5 M A N U A L B E F O R E
B E G I N N I N G A S S E M B L Y
1. Page 21, First Step and Figure 27: Delete the step and figure. They show the installation of the heat sink
which will be installed later.
2. Page 24: Insert the following two steps and illustrations immediately after Figure 33 and before the next
step (make a note in the manual to refer to these errata at that point in the assembly procedure).
If you haven’t done so already, remove the new heat sink from the paper wrapper. The side of the
heat sink that will face the KX3 has been masked keep it free of the powder coating (see figure below).
Remove the masking tape covering this area of the heat sink. The tape is strong. You can peel up one
corner with a sharp tool and then pull the tape off of the metal as shown in the figure.
Removing Tape from the Heat Sink.