Elecraft K60XV Manual Errata - Manual

Page 1 of 1
K 6 0 X V M A N U A L E R R A T A
R e v . B - 3 , D e c e m b e r 1 5 , 2 0 1 3
PLEASE MAKE THE FOLLOWING CHANGES TO THE MANUAL BEFORE
PROCEDING TO ENSURE THAT THE K60XV FUNCTIONS CORRECTLY
1. Page 3, Parts Inventory, Ref D1-D2: Change the description to read “Diode 1N4148”. Change the part
number to “E560002”.’
2. Page 3, Parts Inventory, Ref RF-D19, RF-D20: Add MV209 to the description so it reads “Diode,
varactor, MV2109 or MV209”
3. Page 4, add the following step after the second checkbox step:
Install diodes D1 and D2 (1N4148). Orient the banded end (cathode) of each diode as indicated
by its component outline.
4. Page 4: Last checkbox step, add: Do not trim the relay pins.
5. Page 5: Delete the note at the bottom of the page. It no longer applies.
6. Page 6: Delete the first, second and third checkbox steps (the SMT1B board is no longer used).
7. Page 8, last step: Change the second line to read “(MV2109 or MV209)”.
8. Page 20: On the schematic diagram, update the upper right corner with the changes shown below
around D1 and D1: