Elecraft KAT3 - Manual (Page 9)

9
Remove the five screws shown in Figure 6 from the right side panel to release it. The side panel will lift off
with the 2D fastener and standoff shown in Figure 5 attached.
Figure 6. Removing Side Panel Hardware, Part 2.
Removing the KANT Module
Unplug the antenna connection to the KANT3 board (see Figure 7) then unplug the KANT3 from the RF
board and lift it out. Flex the back panel outward slightly as needed to clear the edge of the board. Holding the
KANT3 board at the top corners, rock it back and forth as needed to release the connector.
Figure 7. Removing KANT3 Board.