Elecraft KDVR3 - Manual (Page 13)

13
Replace the left side panel (with the handle) as follows:
Start the seven 4-40 3/16” (4.8 mm) black flat head screws through the panel: three along the bottom,
one at the top rear, one at the top front, and one just below the front end of the handle. It is normal to
adjust the position of the panels slightly when assembling so the screw holes line up. The cabinet will
become structurally sound and rigid when all the panels, including the top and bottom covers, are
mounted.
Tighten all seven screws. Be sure all the screws are tight, including the screw near the forward end of
the handle that threads into the front panel shield.
Replace the forward bottom cover using seven 3/16” (4.8 mm) black pan head screws (see Figure 5 on
page 7).
Hold the top cover above the K3, route the speaker wire under the stiffener bar and plug it into P25 on the
KIO3 board at the left rear of the K3 as shown in Figure 16.
Figure 16. Connecting Speaker Cable.
Replace the nine top cover screws shown in Figure 1on page 6. Replace and tighten all the screws. Loose or
missing screws may result in birdies or other hard-to-locate problems with your K3.
Preparing the KDVR3 for Operation
Enable the K3DVR module as described in your K3 Owner’s Manual under Option Module Enables.
Your KDVR3 will not operate until you have enabled it as described in the step above.
That completes the installation of your KDVR3 digital voice recorder. Detailed instructions for using your
digital voice recorder are on the following page.