Elecraft PR6-10 Manual Errata - Manual

P R 6 - 1 0 M A N U A L E R R A T A
R e v . A - 1 , J a n u a r y 7 , 2 0 1 5
1. Page 1, Introduction, third paragraph, change “open-source” to
“open-collector”.
2. Page 2, Installation and Operation, Elecraft K3: A Y-cable with
phono connectors is provided to allow you to connect two
devices, such as both the preamplifier and the P3 Panadapter, to
the K3’s 12VDC Output as shown below:
2. Page 2, Installation and Operation, Elecraft K3 Control (CTRL)
Input:
If you are adding the preamplifier to a K3 that already has the
optional KPAK3AUX cable attached to the AUX output and you
want to switch the PR6-10 on and off when the 6 or 10 meter band
is selected with the DIGOUT1 signal, connect the DB-15 Y cable
supplied with the KPAK3AUX cable set and the DE15 Line
Interrupter supplied with your PR6-10 as shown below.
P R 6 - 1 0 M A N U A L E R R A T A
R e v . A - 1 , J a n u a r y 7 , 2 0 1 5
1. Page 1, Introduction, third paragraph, change “open-source” to
“open-collector”.
2. Page 2, Installation and Operation, Elecraft K3: A Y-cable with
phono connectors is provided to allow you to connect two
devices, such as both the preamplifier and the P3 Panadapter, to
the K3’s 12VDC Output as shown below:
2. Page 2, Installation and Operation, Elecraft K3 Control (CTRL)
Input:
If you are adding the preamplifier to a K3 that already has the
optional KPAK3AUX cable attached to the AUX output and you
want to switch the PR6-10 on and off when the 6 or 10 meter band is
selected with the DIGOUT1 signal, connect the DB-15 Y cable
supplied with the KPAK3AUX cable set and the DE15 Line
Interrupter supplied with your PR6-10 as shown below.