Elecraft W2 Watt-meter Manual - Manual (Page 13)

13
Install a 1/4” (6.4 mm) black pan head screw into the mounting hole for the PTT RY connector as shown in
Figure 10. Do not tighten this screw! It only threads into plastic. Stop turning when the head reaches the back
panel. Even though you don’t tighten the screw, it provides critical support to keep the connector from flexing
when connectors are inserted.
Figure 8. Installing PTT RY Connector Screw.
Locate the front panel cover and remove the paint from around the screw holes on the inside surface to it
will make good contact with the other case parts (see Figure 9).
Figure 9. Preparing Front Panel Cover for Mounting
Fit the front panel cover over the LEDs so the holes on the bottom line up with the remaining open holes in
the bottom 2D fasteners. Check the adjacent LEDs carefully to ensure they are all aligned in even rows. If
needed, gently adjust their position for best alignment. This is best done with the cover off.
Secure front panel cover to the 2D fasteners with two 3/16” (4.0 mm) black pan head screws.