ETS-Lindgren 2115 Multi-Axis Positioning Systems (MAPS) - Manual (Page 13)

Maintenance | 13
2.0 Maintenance
Before performing any maintenance, follow the safety
information in the ETS-Lindgren Product Information
Bulletin included with your shipment.
Do not perform maintenance while MAPS is operating.
During maintenance, disconnect power for safety.
Only qualified individuals should conduct maintenance
inspections or perform maintenance on the MAPS.
Regular maintenance will prolong the serviceable life of the turntable. Follow the
recommended schedule and use the log on page 15 to keep a record of
maintenance performed.
If you have any questions concerning maintenance, contact ETS-Lindgren
Customer Service.
Routine Maintenance
Perform the following maintenance prior to each use:
• Visually inspect the Multi-Axis Positioning System (MAPS) and surrounding
absorber.
• Attempt to rotate each axis by hand. Excessive rotation may indicate a loose
drive component.
During MAPS operation, listen for excessive or unusual noise.
Bi-Annual Maintenance
Perform bi-annual maintenance every six months after the MAPS is placed into
operation. Prior to maintenance, remove sufficient amounts of absorber to
provide access to the MAPS casters.
Grease the casters every six months or after every 2000 hours of operation. Use
a good quality bearing grease and a standard SAE grease gun to lubricate the
casters.
WARRANTY