ETS-Lindgren HI-1710 Microwave Measurement System (Archived) - Manual (Page 54)

HI n 1710 Manual Page — 49
APPENDIX A
Command Set (RS-232 Serial Port)
Function Command Range Default
Set alarm trigger point T# 0-9999 -
Set filter number F# 1-4 1
Set range R# 1-4 1
Set peak hold (1=ON) P# 0-1 0
Zero meter Z - -
Initialize system (Reset) I - -
Set 3 or 4 digit display D# 3-4 3
Set print mode M# 0-9 2
Set baud rate B# 12-96 12
Set auto-range (1=ON) A# 0-1 0
Set quiet mode (1=ON) Q# 0-1 1
Set command echo (1=ON) E# 0-1 0
Run self test ST - -
Set status line S# 0-8 -
0 Send system status
1 Send alarm trigger point
2 Send range number
3 Send filter number and filter spec.
4 Send bias voltage
5 Send offset (in milliwatts)
6 Send stim value
7 Send power supply voltages
8 Send current RF reading
Archived 4/2/10