Vermont Casting BHDT36 - Manual (Page 26)

- 26 -
HI
OFF
PILOT
LO
LAVA ROCK
The lava rock provided with this fireplace must be placed
on the firebox base on either side of the burner assem-
bly.
Under no circumstances should this
lava rock be placed on any part of the
burner assembly.
INSTALLATION OF LOGS
Fig. 58
FLAME ADJUSTMENT
For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
knob located near the centre of the gas control. Fig. 59/
60.
Fig. 59
1 . Remove front glass. (See "Glass Removal" Section)
2.
Remove logs from the packaging.
As with all plastics — these are not toys
and should be kept away from children
and infants.
3. Place rear log (BH2) on rear bracket (ensure log is
seated properly, leveled and centered to the unit), so
it will not move from side to side and it is firmly
positioned on the bracket.
4. Place front log (BH1) on front log support. Use log's
bottom holes to locate it.
5. Place top left log (BH3) onto locator notches. Ensure
log is secure.
6. Place top right log (BH4) onto locator notches. Ensure
log is secure.
BH3 BH4
BH2
BH1
SIT VALVE
Turn
counterclockwise
to decrease
flame height
Turn clockwise
to increase
flame height
Honeywell Valve
HONEYWELL VALVE
Fig. 60