Coway MHS-E5010X - Manual (Page 17)

Direction for use / Control panel instruction
Direction for use
Put the power cord in a 120 V~ socket and press the power button.
The appliance will start with a bell sound.
Default setting is [Manual / Sterilized Humidification / Spray -Turbo
/ Humidification Time - Co].
After inserting the cord, make the indoor environment comfortable by following the
instructions for the use of the operation part.
If the appliance is not to be used, unplug the power cord and store the appliance.
SLEEP
CHILD
HEALTH
STERILIZE
PROGRAM
Introduction
Put the water tank on the main body.
Check the water tank is properly seated to the
main body and wait until the water tank is filled
with water.
Check the nano-silver antibacterial tray for cleaning
is properly seated.
If the tray is not attached properly, water will not be
supplied to the water tank and humidification will not
operate.
For the product with iodine filter: Approx. 20 seconds
~ 4 minutes is required to purify the water.
The use of the water fully cooled after boiling or tap water stored for a
day will provide more comfortable humidity.
If the appliance is not to be used for a long time, remove the water in
the water tank and the reservoir thoroughly.
The humidity has a bad smll: The smell comes from chlorine
contained in tap water.
Using tap water stored for a day or water fully cooled after boiling
will reduce the smell.
Weak mist output or no mist output: The appliance may have a weak
mist output when cold water is used or water level is high.
Operate the appliance in strong mode for 30 seconds and then the
appliance will operate normally.
No mist output after cleaning: Foreign materials remain on the
nebulizer. Wash out the inside of the reservoir and the water tank with
clean water and wipe the surface of the nebulizer with a clean brush.
In ‘Weak’ mode, a small amount of invisible water mist is sprayed
but the operation is normal.