Clarion MAX685BT - Manual (Page 61)

Audio Settings
59
MAX685BT
English
Owner
’s ma
nua
l
Adjusting the Tone
You can adjust the sound tone by performing the
following adjustments.
Note:
• These operations are disabled when the DZE
(Digital Z-Enhancer) function is set to other than
“OFF”.
Adjusting the BASS
The bass gain, bass frequency (center
frequency) and bass Q can be adjusted as
follows.
Adjusting the MID
The middle gain, middle frequency (center
frequency) and middle Q can be adjusted as
follows.
Adjusting the TREBLE
The treble gain and treble frequency (center
frequency) can be adjusted as follows.
Adjusting the Balance/Fader
Adjusting the Non-Fader
output volume
You can adjust the volume output from the unit's
non-fader output terminal.
3-1. Touch the [TONE] key to display the TONE
tab screen.
3-2. Touch the [BASS] key.
3-3. Touch the [
[] or []] key for the desirable type
to adjust to a desirable level.
GAIN: –6 to 8
• The factory default setting is “0”.
FREQ: 50Hz, 80Hz, 120Hz
• The factory default setting is “50Hz”.
Q: 1, 1.25, 1.5, 2
• The factory default setting is “1”.
3-1. Touch the [TONE] key to display the TONE
tab screen.
3-2. Touch the [MID] key.
3-3. Touch the [
[] or []] key for the desirable type
to adjust to a desirable level.
GAIN: –6 to 6
• The factory default setting is “0”.
FREQ: 700Hz, 1kHz, 2kHz
• The factory default setting is “1kHz”.
Q: 1.5, 2
• The factory default setting is “2”.
3-1. Touch the [TONE] key to display the TONE
tab screen.
3-2. Touch the [TREBLE] key.
3-3. Touch the [
[] or []] key for the desirable type
to adjust to a desirable level.
GAIN: –6 to 6
• The factory default setting is “0”.
FREQ: 8kHz, 12kHz
• The factory default setting is “12kHz”.
3-1. Touch the [BAL/FAD] key to display the
BAL/FAD tab screen.
3-2. Touch the [
{] or [}] key to adjust to the
fader level.
[
{]:
Emphasizes the sound from the front
speakers.
[
}]:
Emphasizes the sound from the rear
speakers.
Adjustment range: front 12 to rear 12
• The factory default setting is “0”.
3-3. Touch the [
[] or []] key to adjust to the
balance level.
[
[]:
Emphasizes the sound from the left
speakers.
[
]]:
Emphasizes the sound from the right
speakers.
Adjustment range: left 12 to right 12
• The factory default setting is “0”.
3-1. Touch the [OTHERS] key to display the
OTHERS tab screen.
3-2. Touch the [–] or [+] key of the NON FADER
VOL item to adjust to desirable level.
Setting range: –6 to 6
• The factory default setting is “0”.