Hollywood Racks HR1000 SportRider 2 bike version 3 - Manual (Page 3)

Step 6: Install frame hooks:
Loosen knob and slide long
frame hook down vertical post
facing vehicle. Then slide short
frame hook onto post, facing
away from vehicle.
Step 6A: Installing into a 1 ¼” trailer
Fig. 8
Fig. 9
Note: The receiver tube comes
ready for installation into a 2”
hitch. If you have a 1 ¼” hitch,
use the provided hex wrench to
remove the plastic spacer as
shown in Fig. 9.
Place lock washer and flat washer
onto hitch pin bolt as indicated.
Insert the receiver tube into the
hitch. Align the holes, insert the
hitch pin bolt and tighten securely
using a ¾” wrench.
Step 6 B: Installing into a 2” trailer hitch
Place lock washer and flat washer onto hitch pin
bolt as indicated. Insert the receiver tube into the
hitch. Align the holes, insert the hitch pin bolt
and tighten securely using a ¾” wrench.
Fig. 10 Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Install Hitch pin clip
after tightening bolt
Important! When inserting the hitch pin
bolt, the bolt should pass through the
receiver tube first then through the
plastic spacer.
3