Hollywood Racks HR575 Prorider User Manual

Page 4

Advertising
background image

WARNING:

This product is not to be used on

any trailer or towed vehicle.

Drive slowly when using this rack

on bumpy and/or dirt roads

Check the rack and bikes

regularly during use.

13. Mounting bikes on the rack:

Remove the bicycle’s front wheel and place the first bike on the rack,
locating the bike’s fork onto the quick release skewer portion of the
fork mount. Adjust the quick release skewer on the fork mount
So that it holds the bike securely. Mount the bike’s rear wheel into
the wheel tray. Thread the ratcheting wheel strap through the buckle
and close the latch tight. Repeat for the second bike.

Note: The ratcheting straps and 9mm fork mounts must be properly
adjusted for correct installation

.

If you have a question, please see

your dealer or call us at 800-747-4085

To remove the bikes, push in the red button on the
buckle and pull out the strap. Then open the quick
release lever and remove the bike.

Reinstalling the front wheel: Be sure to install the front wheel
correctly per your bicycle manufacturers instructions and
Tighten the skewer assembly securely and correctly!

12. Installing the rack in the hitch: Slide the insert tube into the receiver. Align the hole or
slot on the insert tube with the holes on the receiver hitch. Insert the locking hitch pin through
the holes, and install the locking end to the pin. Tighten the lever H7 on the front of the insert
tube until the slack or wobble has been taken out of the insert tube and receiver.

Limited Lifetime Warranty (effective January 1, 2008):

Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser owns the product

subject to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in materials and workmanship by
repairing or replacing (at its option) a defective part or the complete rack without charge for labor or parts. Hollywood Racks may
elect (at its option) to issue a refund equal to the purchase price paid for the product.

This warranty does not cover problems caused by normal wear and tear including (but not limited to) weather, scratches, dents,

rust, accidents, unlawful vehicle operation, misuse, abuse, neglect, theft, unauthorized modifications, or unauthorized repair. No
warranty is given for defects resulting in incorrect assembly, incorrect installation onto the veh

icle, installation on a “no fit” vehicle,

incorrect attachment of bicycles onto the rack, or overloading of the rack’s weight restrictions. This warranty terminates if the
original retail purchaser transfers the product to any other person.
If a product is believed to be defective, the original retail purchaser should contact either the original retailer or Hollywood Racks
directly at 800-747-4085 or at [email protected]
Disclaimer of Liability: Repair or replacement of a defective product or the issuance of a refund or credit (as determined by
Hollywood Racks) is a purchaser’s exclusive remedy under this warranty. Damage to a purchaser’s vehicle, cargo, bicycles and
or to any other person is excluded. This warranty is expressly made in lieu of any and all other express warranties, whether oral
or written. Hollywood Racks shall not be liable for any direct, indirect, consequential, incidental, special, punitive or any other
damages in connection with the purchase, use or handling of this product.

Some states do not allow the exclusion or limitation of consequential or incidental damages and the above
limitation may not apply to you. This warranty gives you specific legal rights and you have other rights,
which vary from state to state.

HOLLYWOOD RACKS 12812 S. Spring Street Los Angeles, CA 90061

800-747-4085 [email protected]

www.hollywoodracks.com

Customer Service: 8:00 AM to 3:00 PST Monday

Friday

Made in Taiwan

022008 Rev A

Advertising
This manual is related to the following products: