Clarion CMD5 - Manual (Page 21)

21
CMD5
English
Common Operations
AUX function
This system has rear RCA cables so you can
listen to sounds and music from an external
device connected to this unit.
Cellular telephone mute
This unit requires special wiring to mute the audio
signal automatically when a cellular telephone
rings.
* This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
Changing the adjustment setting
1. Press the [MENU] button to switch to the
adjustment selection display.
2. Press the [
E] or [e] button to select the
adjustment item.
Each time you press the [
E] or [e] button, the
adjustment item changes as following order:
“DIMMER”
➜ “CLOCK” ➜ “LOUD” ➜ “NF
VOL”
➜
“SID DISP”
➜ “TV/VTR” ➜ “TV
AREA”
➜ “TV DIVER” ➜ “AUX SENS” ➜
“CONTRAST”
➜ “SCROLL” ➜ “A-CANCEL”
➜ “TEL-SEL” ➜ “TEL-SP” ➜ “TEL-SW” ➜
“RESET”
➜ “SYSTEM CHECK” ➜
“DIMMER”...
3. Turn the [VOLUME] knob to adjust the
selected setting.
* When “ENT” is blinking on the display, press
the [ENT] button to adjust the setting value.
4. After the adjustment is complete, press the
[MENU] button to return to the previous mode.
Notes:
• The adjustment setting is canceled when not
operating for more than 10 seconds (except Clock
and Sirius ID setting).
• When each mode is selected, the item shown in
grey will be displayed.
Dimmer Control
You can set the dimmer control.
* The factory default setting is “OFF”.
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select
“DIMMER”.
3. Turn the [VOLUME] knob to select “ON” or
“OFF”.
4. Press the [MENU] button to return to the
previous mode.
Setting the clock
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “CLOCK”.
3. Press the [ENT] button.
4. Press the [
E] or [e] button to select the hour
or the minute.
5. Turn the [VOLUME] knob to set the correct
time.
* The clock is displayed in 12-hour format.
6. Press the [ENT] button to store the time into
memory.
7. Press the [MENU] button to return to the
previous mode.
Note:
• You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the
boat's battery or take out this unit, the clock is
reset. While setting the clock, if another button or
operation is selected, the clock set mode is
canceled.
Setting the loudness
* The factory default setting is “ON”.
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “LOUD”.
3. Turn the [VOLUME] knob to select “ON” or
“OFF”.
4. Press the [MENU] button to return to the
previous mode.