Home Legend Engineered Ply T&G - Manual (Page 10)

Doc. ID: 125 Rev: 2 Effective: 2/24/2014 Page | 10
Finishing Touches
• Clean the floor.
• Use matching putty where necessary
• Install or reinstall all wall trim pieces. Nail them through the wall, but not to the subfloor to avoid restricting the expansion gap.
• Install transition trim pieces. Nail them to the subfloor, not the flooring.
• At doorways, transitions should be used to protect the edges of the floor and to provide a decorative transition from one floor type to
another.
• If the floor is to be covered, use a breathable material such as cardboard. Do not cover with plastic.
Accessories
Pictures are for general illustrative purposes only. Actual products may differ from picture.
T-Molding is used to create a transition between floor coverings of similar heights or to cover an
expansion gap.
Stair Nose is used in conjunction with flooring installed on stair steps or finished edge of a higher
level floor like in a sunken living room.
Carpet Reducer (also called Baby Threshold or End Cap) is used to transition floor coverings of
differing heights. This reducer strip is also commonly used to border a fireplace, sliding glass door
and other exterior door jambs.
Hard Surface Reducer is used to transition to another hard surface flooring of different heights
such as tile, vinyl, concrete.
Quarter Round is used to cover the expansion space between the Wall Base and your flooring. It
can also be used them to make smooth transitions between the floor and cabinetry. It can be used
with or without Wall Base molding.
Wall Base is used to give a finished look at the base of the walls. It can be used with or without
Quarter Round.
Technical Support
For installation information and technical questions not covered in this installation guide, please contact our Technical Support
Representative by calling the toll free number below.
Toll Free Number: 877-630-1800 or 877-960-8001