Hybrid Racing HR EG DC Kswap Mount Kit User Manual
Page 5
Advertising
5
Install Guide
STEP 10: Bolt Transmission/
DRIVER SIDE MOUNT BRACK-
ET DO NOT FULLY TIGHTEN to
the transmission. On this mount
your going to want to use the
hole that corresponds with the
same option you chose in step 5.
Do not tighten these all the way
until the engine is in the car.
When you do tighten them go
40ft-lbs
STEP 12: If you have access to a
lift we recommend lowering the
car onto the engine. If you have
access to an engine host go
ahead and lower it from the top.
STEP
STEP
STEP
12
12
12
STEP 1
STEP 1
STEP 1
1
1
1
STEP
STEP
STEP
10
10
10
STEP 11: Remove the stud from
passenger valve cover side en-
gine mount using the same meth-
od as in step 9 above.
Z
X
Advertising