ISSPRO R7708 - Manual

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211
Telephone: (503) 288-4488 Š Toll Free: (800) 888-8065
FAX: (503) 249-2999
Form No. IS019 (7/19/01 Rev. A) Page 1 of 1
ISSPRO DUAL GAUGE HOLDERS
(Partial Pillar – All Models)
ASSEMBLY INSTRUCTIONS
Your carton should contain the Gauge Holder and a package containing six fasteners (“Christmas
tree pins”), along with these instructions. You will need a 3/16” drill to install your Gauge
Holder.
1. Position your Gauge Holder on the A-pillar where you want to mount it and mark the
A-pillar accordingly.
2.
Remove the stock A-pillar.
3.
Install the gauges into the Gauge Holder by pressing them into place.
4.
Make an opening in the A-pillar for the gauge lines to fit through.
5.
While holding the Gauge Holder over the A-pillar in its finished location, run the
gauge lines through the opening in the A-pillar and check to make sure there is no
interference with the gauges or the lines.
6.
Drill 3/16” holes through the four corners of the Gauge Holder and through the A-
pillar. Note: Some minor trimming of the Gauge Holder may be required in some
applications for a perfect fit.
7.
Insert the “Christmas tree pins” through the drilled holes to secure the Gauge Holder
to the A-pillar. The other two pins are spares.
8.
Run the gauge lines through the opening in the A-pillar, down the back and through
the firewall to the engine.
9.
First, re-install the A-pillar; then attach the gauge holder to the pillar, checking for
sufficient wiring length (2” of slack recommended). Take care not to pinch the gauge
lines in the process.
LIMITED WARRANTY
ISSPRO, Inc. warrants to the consumer that its gauge holder products will be free from defects in
materials or workmanship for 1 year following purchase by the end user. Warranty is limited to
replacement or credit at ISSPRO’s option, of defective parts within the warranty period. Parts must be
returned, prepaid, to the original purchase point for warranty inspection. This warranty does not apply to
misapplication, misuse, negligence or accident. This warranty is in lieu of any other expressed or implied
warranties, including any implied warranty of merchantability or fitness for a particular purpose, and of
any other obligation on the part of the seller. In no event will the seller be liable for incidental or
consequential damages.